Hi, I've been asked to configure a switchport to match the one next to it.  easy enough right, except there seem to be some commands required that are not in the config.   Can you help?   Here are the 2 ports:SWITCHA#sh run int fa5/10Building configu...

Hi All,  I've been asked to make some design recommendations.  The 1941 and 2921 would be a good fit for this customer.  Anybody know if there are plans for these routers to go EOL anytime soon? Thanks in advance

Hi,  I have several Cisco 2960 switches. I'm pretty sure the data sheet says it only has 2 gigabit uplinks.  However, I see 4 uplink ports (2 are copper and 2 are fiber) and I see 4 gigabit interfaces in the switch config.   I would like to use 3 of ...

Hi,  I have a bunch of 2960.  planning on daisy chaining them together and then patching into a 4507.  In earlier versions of hw/sw you could use either the fiber port or the copper port, but not both. in the config I see:interface GigabitEthernet0/1...

I'm trying to do a password recovery on a 2960 switch. here's what I see: switch: dir flash:unable to stat flash:/: invalid argument switch: dir List of filesystems currently registered:                   bs[0]: (read-only)               flash[3]: (r...