About unwell_11

unwell_11 · 07-23-2014

Hi All,Previously, we are using CUCM 9.1, H323 gateway, and ISDN for inbound and outbound calls without any issues.Last night, we tried to use SIP for outbound calls to one of our local SIP providers. Everything seems to be working fine, but when te...

unwell_11 · 03-14-2018

Note that you can use Jabber in "phone mode only". You will not need IM&P for this type of deployment.

unwell_11 · 09-07-2014

FYI. After two or so weeks with TAC, it boiled down to changing one service parameter in CUCM. This was causing CUCM to send a=sendonly, instead of actually sending a=sendrcv.

unwell_11 · 07-24-2014

Hi Tere,This is what is on the link:Note To prevent the SDP mode from being set to inactive in a multiple-hold scenario, set the Duplex Streaming Enabled clusterwide service parameter (System > Service Parameters) to True.But, we are are not doing ...

unwell_11 · 07-23-2014

Thanks, Tere! I'll read through the document you provided and make the change. I'll keep you posted if this fixes the issue. Thanks again!

Member Since	‎07-23-2014 02:13 AM
Date Last Visited	‎03-20-2018 10:58 PM
Posts	5
Total Helpful Votes Received	10

User Statistics

User Activity

One-way audio after call is put on hold

Re: Cisco IP Communicator disconnecting issue after undocking.

FYI. After two or so weeks

Hi Tere,This is what is on

Thanks, Tere! I'll read