Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!
I have cisco WLC and three cisco 1522 access points. The problem is that only one access point has two radio interfaces, so it has 802.11a and 802.11b/g.
Radio InterfacesNumber of Radio Interfaces
2
UP
Radio Slot#Radio Interface TypeSub BandAdmi...
Hello everybody!!!
I have a problem with my wave-574. It doesnt respond anything. I've tried to connect via telnet or console cable, tried to reload by pulling out the power cable but nothing had change. Only power button led is amber and others are ...
Hello Guru of Cisco !!! I have a problem with STP.... I have a switch 3560 and its connected to the core switch by Cisco Aironet 1410 and cisco modem 878. I configured on switches RSTP. But when i open two interfaces in 3560 where connected Aironet ...
Hi Sandeep!!!
I upgraded the firmware from 5.2.192 to 7.0 series. Blinking RED led stopped, so RF-1 indicator is off. But the 802.11a didnt appear.
Cisco Controller) >config 802.11a enable one_radio
AP does not support the specified radio type.The f...
(Cisco Controller) >show ap config general two_radio
Cisco AP Identifier.............................. 6Cisco AP Name.................................... two_radioCountry code..................................... US - United StatesRegulatory Domain a...
