Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a 1117-4PWE ISR router running ios-xe version 16.9.2 which I am trying to configure as a stand-alone (controllerless) wireless AP. I've been referring to this document on the Cisco website but absolutely tearing my hair out struggling to tr...
Hi,
I'm trying to add Radius authentication and authorisation on an IOS router.
Authentication works fine but having problems with authorisation. I think the issue is the radius server I'm using but hoping someone might confirm and suggest if the...
Hi,I'm trying to set up vrrp between a Cisco 800 series ISR and a Fortigate VM firewall. Please see diagram below. Should note this is mainly about the Cisco, not the Fortigate.I'm having a bit of trouble with the VRRP on the FG. It takes master stat...
Hello all,I have a very weird issue at the moment is a Cisco 887 DSL router running IOS Version 15.2(4)M6.The IP address of a LAN device appears in the router arp cache but does NOT appear in the switch mac-address-tableEven if you ping the end devic...
Ok, I don't know if you're asking me to run those specific commands on the device and post the output? At any rate, those are the commands I've been running to get to this point but here's the output anyway.BMT-45959#ping 192.168.1.65Type escape sequ...
Hi Jeffery,thanks for your input.The LAN device is an IP-handset. I believe it's a Cisco 525.Yes, I issued a show ip arp (well, show arp - Got the same result from both) and yes I am using show mac-address-table to check the CAM table.The LAN is conf...
