Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have an SVI 100 configured in Cat6K w/ IP 10.1.1.1/24. Then, about 50% of the host IPs are already in use by several servers.Now, I would add a new server that would generate both IP and SNA traffics. For this, I would configure loopback0 IP...
Hi All,I got this setup and kindly let me know if this would form a bridging loop:4006 --(trunk)-- 3550 0/1--- e0 3640 e2 --- HOST 0/2 e1 | | |_____________|In the above setu...
Hi all,I am troubleshooting a DLSw peering problem. There are firewalls in between (not in my hand to check) so I would like to know in which segment was the DLSw traffic able to reach (or not).Here's our simple DLSw traffic path:3640(DLSw)---2950swi...
Questions:1. If an existing VLAN (with hosts) would be configured as a primary vlan to enable PVLAN, would this affect the original VLAN hosts (they will not be part of any isolated or community VLAN)?2. Would a PVLAN community host/PC be able to com...
i hope anyone won't mind me getting in. i haven't read entirely the conversation but the question concerning port-channel in L2 & L3, i don't think there is a L3 port-channeling. As far as what i currently know, port-channel operates only in L2.I thi...
Hi, I assume that you directly connect the tftp server to the router's e0 through a cross-cable or w/ a "simple" switch in between.Have you tried to remove the "ip nat inside" configuration in the router's e0?rodroble
I actually enabled IRB, but maybe along the way, I missed the point that my setup might work even w/o the e1. I'll check and test my setup again.My question is answered. Thanks!
