About kkwaskcisco

kkwaskcisco · 01-16-2015

Hi there;In my core network switch, I have multiple VLANs, I have these command to assign to DHCP pools. I configured a port on my core switch for DMZ_VLAN and when I connect my computer to this port, I can get the ip address from the dmz_vlan dhcp ...

kkwaskcisco · 01-10-2015

Hello; I want to implement dual firewalls in my network, one facing to internet and another one facing to LAN, currently I have a Firewall B facing to internet and LAN and have a IPsec VPN for site to site. If I need to place a new Firewall A in fro...

kkwaskcisco · 10-16-2014

Hi; How can I configure the PAT on my 5512 to allow smtp traffic coming from the internet? I have one public ip only, but I need direct the smtp, http traffic to two different server internal.

kkwaskcisco · 08-15-2014

Hi; I am using ASA 5512x, I have a VPN tunnel with remote site, and it is up. I can access to their subnet 172.16.0.0/24 subnet which is added to the wizard during site to site VPN configuration. In remote site, there is another subnet 172.16.1.0/2...

kkwaskcisco · 08-10-2014

Hi;I hav a ASA5512X firewall with 6 interface, interface 0 has been assigned to a WAN connectivity with ADSL, in which my ISP gave me two static IPs (not a block range of IP), my ISP mapped the Mac address of an interface to a ip address, this is wha...

kkwaskcisco · 01-21-2015

thanks for your response. I have to try it out again. I believed that I might use the wrong gateway ip in my dhcp commands.Because I use the DMZ interface on firewall as the gateway while configuring the dhcp for dmz network.

kkwaskcisco · 01-16-2015

in my layer 3 switch, there are different vlans, a transit vlan is used to connected the firewall and layer 3 switch for all traffic from lan side going thru.And a network cable is used to connect the access port on layer 3 switch to the dmz port on ...

kkwaskcisco · 01-16-2015

Hi; thanks for the response.there is a typos for interface vlan 10 ip address 10.10.1.254 it should be interface vlan 10 ip address 10.10.1.1 For the default router in the dmz_pool, 192.168.0.1 is the dmz interface IP on my firewall. def...

kkwaskcisco · 01-16-2015

Hi Jouni Thanks for your response. The reason of placing a 2nd firewall facing to internet is for security reason, try to enhance the security in network.I was thinking to put the route also but not sure if this is the correct path to do. I was thi...

kkwaskcisco · 10-30-2014

Hi;Did you check the Perfect Forward Secrecy? By default, Juniper firewall enable this feature. Try turn it on at your Cisco firewall.

Member Since	‎08-08-2014 02:21 PM
Date Last Visited	‎08-18-2017 04:02 AM
Posts	17

User Statistics

User Activity

Multiple DHCP on Multiple VLAN not working

How to implement Dual firewall.

PAT configuration on ASA 5512

How to connect to another subnet via VPN?

How to configure ASA5512X DMZ with a Public IP address?

thanks for your response. I

in my layer 3 switch, there

Hi; thanks for the response

Hi Jouni Thanks for your

Hi;Did you check the Perfect