Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,i have couple of WAP4410N wireless access points, i have tried to setup connection control (MAC Filtering) with RADIUS server.i have also disabled Wifi Security, but its showing wifi is protected with WEP upon scan.i cannot connect any devi...
Greetings,i have 2 Subnets on Cisco 2911 router192.168.3.0/24 and 192.168.1.0/243rd Network 192.168.4.0/24 is natting internal interface to modem for internet access. which creates 2 NATs (NAT in router and NAT in Modem)i have just bought Cisco ASA 5...
so in short setup should be like this Cisco 2911 - 3 Subnets 192.168.1.0 - 3.0 and 4.0 - NO NAT Here. ASA's Interface with IP 192.168.4.1 should be default route for Cisco 2911 Router ? while ASA's other interface is connecting directly to Internet ?...
no, i will be removing modem as and replacing it with ASA. but i dont think Internet access will work while NAT removed on Router. should i point 192.168.4.1 (ASA IP) as default route on Cisco Router? and remove NAT from it.will NAT work on ASA ?
