Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to develop an AAA deployment for switch access that will give users access to 'enable' mode without re-authenticating.
I'm using a 2960x running 15.2(2a)E1 code.
Here's my config:
aaa new-modelaaa authentication login default group tac...
We have 2 SPA-112 units (running the latest 1.3.3(015) firmware) which are experiencing loss of registration on a regular basis. The web interface shows that the line is off-hook, and that it is registered. However, there is no dial tone on the li...
When you say 'put or remove exec authorization', how do you mean? I'm trying to do that with this command, which I believe should grant exec authorization when the user authenticates (but perhaps I misunderstand):
aaa authorization exec default grou...
Hi Gagandeep,
There is no failure (and no error), but simply an unexpected behaviour.
I agree that I should get enable mode, but I don't. I can demonstrate the difference between sending priv 1 and priv 15 via TACACS, and the behaviour persists w...
I had a very long back-and-forth with Cisco small business support. They recommended the firmware which was released just a few days ago (1.3.5). I upgraded the firmware, and also applied a patch to the 3300 that Mitel released just for us. We hav...
For interest's sake, here's the SIP log from the device at the time of packet #1231 and #1245:Aug 25 09:41:09 10.10.0.41 ################# CC: running... ############Aug 25 09:41:53 10.10.0.40 ################# CC: running... ############Aug 25 09:...
Dan, this is an utterly fantastic analysis.I'm going to go through your advice bit by bit. One note: the .24 node is the on-site SIP proxy, which is a Mitel Border Gateway.Thank you!
