Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Recently I've bought the WAP371 access point (European version) and updated it with the firmware 1.0.0.10.Unfortunately this device does not work properly in the frequency band of 5 GHz, in the frequency band of 2.4 GHz it seems to work fine.The i...
Finally, I was testing the WAP371 under low power requirements, i.e. in the configuration after factory-reset ("Single Point Setup" disabled, no "Captive Portal" no SMTP, etc,) and with only 5 GHz band enabled. As mentioned earlier, I powered the dev...
Thanks for this idea, but the problem seems not to be concerned with the power supply.Actually, just to be sure of this, today I powered my WAP371 by a professional regulated power supply with a nominal voltage of 12 V and max. current of 3A.I was m...
Hello,Thank you for your response!I've tried both, a 12V DC power adapter and a budget PoE injector supporting IEEE802.3af.In both cases the results were the same - disconnections after data-transfer of approximately 1.4 GB (or sometimes after 4 GB ...
