Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,
We are implementing a lot of RV320/325 routers plus SG-300 switches at customers.Usually we use 2 VLANs. the standard 1 for normal use and 1003 for guests.
Now since both can do DHCP and DNS I was wondering what you all use and what best p...
Hello there all,Has anyone else noticed the router logs (RV320/325) showing this a lot? 2015-09-06, 00:59:25Kernelkernel: xt_TCPMSS: bad length (589 bytes)
Hello all,We have a Cisco RV325 Router and behind that a SG300-28PP Switch.Before we used to let the RV325 do all routing, dhcp, dns and also enable VLAN there.Now I was thinking, would it be better to move the VLAN stuff directly to the SG300 switch...
Hello there,So for the whole day today ive been trying to figure out how this IPV6 stuff works with RV320/325.My ISP gave me the following information:IPV6 adres directly behind our modem:Network adres: 2001:44f0:3071:0:0:0:0:0 ip subnet -mask: /64Ga...
Hello everyone,
After a whole lot of testing (years of work!), I think I have finally figured out the best configuration for WAP series. By default they have some problems with Apple devices disconnecting every couple of minutes, with Airplay and so ...
For 2.4Ghz try to use : 1, 6 or 11For 5Ghz you can usually keep each access point at : 36, 44 or 48 since the signal doesnt go as far as 2.4.
Another couple of tips that work: https://supportforums.cisco.com/discussion/12338441/wap-device-best-practi...
That depends, usually (in the case of iphones for example) they will decide themselves when they switch (they look at the signal strength and difference). Ofc, you can play with the signal strength of each access point and lower it so they dont overl...
There is no specific setting to make clients roam between these devices. Roaming works best when being used between WAP models of the same series. So for example Multiple WAP371 or WAP571 or 321.
As long as you use the same SSID (with different chann...
Hello Matthew,
From my own experience with the 571, the 2 LAN ports can indeed be used for LAG to balance load between both LAN interfaces. This is especially handy for when clients need speeds that reach 1Gb/s and you ofc also have other clients co...
