Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,I've been having an annoying problem with the Access Point 350. It all started last summer while I was away on holidays and the access point actually wasn't used.Anyway, when I came back the throughput was suddenly much less than it was befo...
Hi!I've been having a problem lately with following setup: 350 AP, newest firmware, reset to defaults. 350 PC-Card, newest Software Package & Firmware.Signal strength between 90% and 100%. Signal quality between 60% and 70%.Problem: When I transfer d...
Hi Everyone!Lately, I have been having an annoying problem with my Cisco 350 Access Point and PC-Card. Everytime, data is being transferred over the wireless connection, the speed drops down to 2Mbps and recovers to 11Mbps, when the data is no longer...
Actually, I do. When transferring data, the CRC errors increase rapidly.Regarding a site survey test, what would be "normal" values for a site. I've set the channels according to what the manual says is the best frequency after doing the survey, but ...
Hi!Thanks for helping me. The client reports 21,418 PLCP CRC Errors and 14216 MAC CRC Errors, within 4,5 hours of up time and 17Mb Transmitted.Does that qualify as "a lot"? The firmware on the AP is 12.03T. I've gone through all the channels, but wit...
