About Travis.voth

Travis.voth · 09-07-2014

I have been beating my head against the wall at this the last few days. I am trying to configure two 2960X switches that are going to be connected with a fiber home run with no ISP or router involved. I have both switches MGMT Vlan set to VLAN2 wit...

Travis.voth · 09-08-2014

SW1 Config:VLAN2 10.101.1.34/27 YES NVRAM UP UPVLAN 4 10.101.1.126/27 YES NVRAM UP UP SW2 ConfigVLan 2 10.101.1.33/27 YES NVRAM up upVLAN 4 10.101.1.126/27 YES NVRAM up up

Travis.voth · 09-07-2014

UPDATE: After getting IP Routing configured I can now ping VLAN4 from SW1 and SW2 connected via a VLAN2 port. I cannot, however ping all the way through from Laptop (10.101.1.40/27) to PC (10.101.1.112/27). I also went back to my /27 CIDR so I can ...

Travis.voth · 09-07-2014

I am fairly new at this. I have tried routing (Ive defaulted the switch many times re-trying config). This is what I had on SW1:(config)Ip route 0.0.0.0 0.0.0.0 10.101.1.34(config)Ip routing(config) Int Vlan 2(config-If) 10.101.1.33 255.255.255.0 S...

Member Since	‎09-07-2014 08:51 PM
Date Last Visited	‎08-18-2017 04:02 AM
Posts	4

User Statistics

User Activity

Cannot ping two VLANs on same network on a 2960X switch.

SW1 Config:VLAN2 10.101.1.34

UPDATE: After getting IP

I am fairly new at this. I