Mohammed,Go into interface configuration mode on the outside local interface (the one facing the Internet). Use the 'ip nat outside' command to make it the outside interface for NAT.Go into global configuration mode and create an access list to enco...
Mohamad,I'm not sure what command you entered to generate this error, but the link below may help clarify your issue.https://supportforums.cisco.com/discussion/10952716/static-arp-entry-command-no-worky-vlan#comment-5595721-Mike
Dave,The list of officially supported Android phones can be found at the link below, but note that other phones may work with Jabber Voice, even if it is not officially supported at this time.http://www.cisco.com/c/en/us/products/collateral/unified-c...
himanshu, These switches could both be the root bridge for different VLANs, depending on your configuration. If you enter the 'show spanning-tree' command, it will list all VLANs and indicate if that switch is the root using the statement 'This brid...