Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I have problem with SIP phones which are registered with their public IP on CUCM instead of private address assigned to AnyConnect client. (AnyConnect client for android v4.9, ASA with firepower module v9.8(4)) Now, SIP clients are successfu...
Hello, I have ASA 5512-X with firepower (v5.4) and FS750 appliance (v5.4). Everything is connected and configured as per instructions on:http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/sfr/firepower-qsg.html#pgfId-144598
Detailed pictur...
Strange behaviour on two of my 8 HSRP groups.Active HSRP router doesn't see standby router because it doesn't send him hello messages.When I go to standby router, and start "debug standby error" I get messages:"Cannot determine src IP address for Hel...
After some testing problem was detected with SIP client application. If split tunnel is set to Tunnel all networks SIP application registers with correct IP address. I believe this is because in this case Any Connect is set as default gateway on clie...
Hi, after reading this discussion and some other, Im still not clear with setup for directly connected APs.
I have one 2504 v8 WLC and two AP series 2700. Also I need to configure multicast for Apple and Chromecast.
In attachment you can see my plan ...
Well, I'm not sure is it expected, because in both cases real IP and virtual IP were in same subnet.Also, configuration on Active HSRP router is working with no problems:int vlan 30ip address 192.168.30.2 255.255.254.0standby 30 ip 192.168.31.254
Problem solved, thanks for help.There is some kind of bug I believe... Network where I had a problem is: 192.168.30.0 mask 255.255.254.0vlan interface on standby router was configured like:vlan 30ip address 192.168.30.3 255.255.254.0standby 30 ip 192...
