Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
fellow cisco users, we have deployed approximately 15 Cisco C819HG ISRs to remote locations. _all the routers deployed are of the 4G Verizon version and they work very well. _my issue is, when the wireless carrier service drops and comes back in 3G m...
i have a C819 router with 1 Vlan interface, 1 Gig interface, 1 Cellular interface and a NAT configuration issue. I use CCP to configure NAT for the router with Vlan1 trusted and Cell and Gig interfaces untrusted. When i configure Vlan1 and Gig 0 inte...
my cisco isr 819 constantly cycles between the gigabyte interface and the cellular...? _i have the device configured for auto failover with the gigabyte interface being the primary and the cellular as backup. _i used Cisco Configuration Pro to config...
cinthia, thank you very much for your input. _and it turns out your recommendation is part of my fix. _i opened a support ticket with cisco.com who held my hand and got me through this event. _i had about three different areas in my configuration tha...
yes, but it doesn't seem to help...still a NAT issue. My configuration is NAT'ing the out going Cell 0 WAN packets now. Then the router detects the Gig 0 WAN is restored and changes the route table to the Gig 0 WAN which disables Vlan1 host internet ...
Yes you are correct Cinthia, it is the NAT and depending on which external interface i configure first with NAT, that's the only interface providing NAT to out going packets.What i hope to achieve with my C819HG ISR router is provide the G0 interface...
