Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I did a swap of ASA 5520 to 5525-X. Nats are working fine but users cannot display the interface when using RDP.
The sessions are very slow compared to the old ASA.
When I did a rollback to ASA 5520, the RDP sessions are working correcty.
...
Hello All,
I tried to swap an ASA 5520 (8.2 ) to a new ASA 5525X(9.3).
In the Lab, all static nats and dynamic NAT were working correctly .
But when I tried the swap in production, all traffic to Nated addresses are failing (teardown). Dynamic Nats (...
Hello All!!I cannot see VEM module in VSM after installation.I checked the connectivity in the same vlan with ESX host and VSM.Both are able to ping each other.Please have below my card info on ESX.~ # vemcmd show cardCard UUID type 2: 5f8a22e2-2d09...
Hello Peter,
Indeed, I faced this issue but I cleared the mac address table on the second deployment to make it work. All Static Nat are working now.
Thanks,
Hello Philip,
The plugging are not same. In the next deployment, I will try to connect other cables.
I made a mistake when replying and I hit the correct answer button. I don't know how to undo it.
Thanks.
Hello Philip,
I migrated the new ASA with tcpmss (1380) but the RDP sessions were slow.
The existing ASA (5520) which is in production has also the same size of tcpmss but RDP sessions are fine.
I'm wondering whether I should increase the size in the...
