Hello Experts, I have this setup where i need to make sure that hub should route all other spoke to primary spoke at location A, secondary spoke should be used only when primary spoke is not available. I am running eigrp between hub and spoke. I tried influencing the routing selection by changing delay at tunnel interface on secondary spoke, this did not make any difference at the hub site. Can you guide me on what is it that i am not doing correct here? Appreciate your help in this matter, Thanks, Pulkit
... View more
Hello Giuseppe, I have done the same in my branch routers (two of them), but this is not reflecting in routing table at HO side. is there anything else that i need to do after changing delay? like clearing relationship or something else. I labbed this up in GNS3 and it worked without any clearing of neighbors. I am stuck now.. :-( thanks in advance, Pulkit
... View more
Hello Giuseppe, I have a setup where we have two spokes and one hub. i need that only one spoke is used in DMVPN while other serve as backup in case primary spoke fails. now the problem is even after changing delay on tunnel interface in spoke router, hub is still using both in routing table. basically this change in delay is not reflecting at hub site. i changed delay using delay configuration at interface tunnel. do you recommend something else? or shall i change the distance from secondary router. Thanks, Pulkit
... View more
