Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to apply an ACL to a couple of VLANs in my network of Catalyst 3750 switches (operating in layer 3 / IP routing mode). One point on which I am not clear is whether I need to create and apply the ACL on each switch, or whether I can create it ...
I am trying to install a wildcard certificate on an ASA5505, but it isn't showing up after installing it.
The cert is in use elsewhere just fine. I installed the intermediate CA cert and that shows up just fine. I import the PKCS12 format file (als...
This was the fix for me:
Control Panel | Administrative Tools | Local Security Policy.
Under Local Security Settings, | Local Policies | Security Options.
Enable the policy -> System cryptography: Use FIPS compliant algorithms for encryption, hashi...
I think I grasp what you are saying. Let me run out a slightly detailed "what if" and see if I'm getting it right...
Say I have VLAN 1, 10 and 20, with IP ranges of 10.0.1.x, 10.4.1.x and 10.4.7.x respectively. These are configured on two switches...
The VLANs in question are for restricted Wi-Fi connections. The intent is to block traffic from IPs on those VLANs going to any internal (or VPN connected) resources other than the DHCP server and our edge ASA for egress.
My intent is to put a coup...
Thanks! That led me to the solution. When I tried those steps, I got as far as "enrollment terminal" when this error came up:
ERROR: Trustpoint enrollment configuration cannot be changed for an authenticated trustpoint.
A little digging and I quic...
