Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a single WLC 5508 on my network at this time. I have 108 access points all CAPWAP associated to it. I am in the process of configuring two new 5508 controllers in a HA configuration. The IP address of the primary will be the same as the IP ...
I was hoping to be able to access the gui from the laptop it is running on, but the VM takes over the machine. I assume I will need to launch the gui from a different device?
I have installed the emulator on a laptop running VMware workstation player. I am not able to access the gui. I can only access the cliuser or config options. Any help would be great.Thank youDave
