Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am new to managing a particular network where I work and I discovered that the secondary PIX does not have a config when I do a "show conf". The primary PIX is active and I see the config on it. I want to copy the active config over to the second...
when setting up IPSec between Cisco VPN Client 4.0.4 and a PIX 525 ? First and foremost I guess, do I have to configure Xauth user authentication in order for IPSec to work between the VPN Client and PIX firewall? I do not have a TACACS+ server and...
I configured it to point to my mail relay and to email me atmy yahoo account. The problem is that the report that I receive in my email contains a hyperlink back to my IDS admin PC. This is an issue as we have a firewall and not everyone can access...
Is this possible? How do I set this up? Basically, I need to configure the PIX remotely from the internet using the PIX Device Manager.. Any help would be appreciated. Thanks in advance.Tom
They come from the internet through our T1, go through the PIX, and hit our PC via Terminal Services and are able to connect ok. They then bring up the Cisco VPN Client to connect out to a VPN concentrator via the same T1 they came in on. This VPN co...
So If I am missing the correct pdm location statement will I still be able to access the PDM assuming I have the other 2 commands and am accessing it from the respective inside network:http server enablehttp 10.0.0.0 255.0.0.0 inside
It may be due to the version of IE you are running. I had a similar problem when I upgrade my PC to IE 6.0. After this I got a pop-up saying that my PIX was of an "unkown version" which was nuts because I never upgraded the PIX. I may try to use N...
