About john.paul.albe

john.paul.albe · 10-13-2014

I'm getting the following fault on two of my B200-M3 blades after doing a firmware infrastructure autoinstall from 2.2(1d) to 2.2(3b). Firmware update was successful on everything, so I'm not sure why something happened to the blades.The UCSM is cla...

john.paul.albe · 10-14-2014

Answer was to disassociate server from profile, remove server from default pool, yank it out of the chassis, put it back in, re-add to default pool, re-associate with service profile.As they say on the IT Crowd, "Did you try forcing an unexpected reb...

john.paul.albe · 10-14-2014

I disassociated the server and pulled it out of the chassis and then plugged it back in. Not sure if that would have the same effect as CIMC reset...

john.paul.albe · 10-14-2014

NameModelRunning VersionAdapters Adapter 1Cisco UCS VIC 12402.2(1d)BIOSCisco UCS B200 M3B200M3.2.2.1a.0.111220131105Board ControllerCisco UCS B200 M311CIMC ControllerCisco UCS B200 M32.2(1d)

Member Since	‎10-13-2014 12:09 PM
Date Last Visited	‎08-18-2017 04:02 AM
Posts	4

User Statistics

User Activity

UCSM unable to monitor storage on blade after Firmware update

Answer was to disassociate

I disassociated the server

NameModelRunning