About aqueebqadri

aqueebqadri · 04-23-2016

Hi All, My company has full VPN tunneling through the AnyConnect client. The issue is that I lose SSH connectivity to all my "Host-only network" Virtual Machines set up through Oracle VM VirtualBox. Is it possible to add a route like "netsh interf...

aqueebqadri · 10-15-2014

I am trying for forward UDP port 43139 to an IP on the inside, but whenever I do the forward, I get the error "ERROR: NAT unable to reserve ports." The commands I enter are as follows:-object network AQUEEB_UTORRENT_UDP_43139host 10.55.17.2nat (insid...

aqueebqadri · 04-23-2016

Hmmm...every time I add another "host only" network card, the AnyConnect client disconnects and reconnects and updates the route table. VERY frustrating. Time to find another way out of this dilemma. Thanks for all your help!

aqueebqadri · 04-23-2016

Interesting suggestion, let me try. I'll post back the results. Thank you.

aqueebqadri · 04-23-2016

So there is no way around this? A "hack" or something?

aqueebqadri · 10-19-2014

Thanks again for all your help. The reason why port forwarding was not working was because my dynamic nat rule for my inside network was in Section 1. I moved it to section 3 and port forwarding started working.Aqueeb

aqueebqadri · 10-16-2014

The rule that I have on the ASA device to get the traffic working is the access-list applied to the interface outside. Basically the following two lines. access-group outside_in in interface outsideaccess-list outside_in extended permit udp any host...

Member Since	‎10-15-2014 04:55 PM
Date Last Visited	‎07-20-2020 03:17 PM
Posts	9
Total Helpful Votes Received	5

User Statistics

User Activity

How do we override routes by the AnyConnect Client?

UDP Port forward on ASA 5510 9.0 (4) causes "ERROR: NAT unable to reserve ports."

Hmmm...every time I add

Interesting suggestion, let

So there is no way around

Thanks again for all your

The rule that I have on the