Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day all,
please can someone help me with the configuration on how to enable auto-update of IPS signature
on a cisco router 2911. This is my configuration. on the username, i put my cisco ID and cisco account password , i want to know if it is wh...
hi all,i have a cisco router 2900, IOS software version of 15.4(3)M1.I tried to setup a site to site ipsec vpn on my router and type 'crypto ikev2 proposal prop_1',on the configuration mode. the router is not accepting the command. when i do 'crypto ...
Please i use download and upload 6meg/6meg and i have two networks that are connected to it. please is there anyway i can load balance, so that i can allocate 4meg/4meg to one network and 2meg/2meg to another network?
Good day all,please i have a problem that i need to reconfigure with my IPS. i configured my IPS on inline mode and is affecting the speed of our network. i was asked to change it to promiscuous mode. please i need a help on how to go about this. wi...
Good day all,please i wanted to download anyconnect vpn client 64 bit win 7 from software.cisco.com and i was not able to do that after login in. please can someone help me on how or the steps i can take to get the download.secondly can i be able to ...
Good day Abaji,This is my configuration. 41.184.38.218 (Gi0/0) is my primary link, 105.235.195.202 (Gi0/2) is my backup link while 197.210.199.154 is my peer ikev2 site-to-site vpn linkwhen i finished my configurationthe internet went down, until i r...
thanks Abaji.i have another problem. i was able to setup the site-to-site ikev2 on my 2911 router. in my configuration, i configured primary link and backup isp on the router as a failover. after the configuration, i does not get internet, until i re...
thanks Bilal. let me break it down, i have two internal networks. 172.168.1.0/24 on f0/1 and 192.168.1.0/24. both are on physical interfaces on the router. and the interface from the router that link outside through my ASA is gi0/1. i need split my ...
hi,please i have a little problem on denying some ip address from been cached on my cache box. i used my cached box to block many websites on my inside network 192.168.1.0/24. but i want to permit a few ip addresses to have access to those website by...
Hi, thanks for the information, but i think my own topology is different. i have the ASA firewall which is connected to the outside interface and a cisco router connected to my inside interface of my ASA with this subnet 192.168.5.0/30 and my inside ...
