Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Cisco Support Community i have a problem on one of my 1310 wireless bridge it is stucked on flash memory test and after resetting the baudrate to 115200all i see on the bridge is status and Ethernet Leds are blinking green. Can you please help m...
I have Cisco 1310 wireless bridge and i don't know how but its operating system is not working any more i have the operating system in Tar file but when i try to upload it to the bridge it gives me the below message and i cant figure out what the...
and for this reason i am stucked. On the CLI there is Unknown character i cant login to the bridge any help on how i can login to the CLI will be appreciated
Hi,I have managed to Upload a new IOS using Xmodem and it was working fine Thanks for the advice and now i am being challenged with another issue "Baud Rate"the story is the IOS that i have uploaded on my the bridge is faulty so i wanted to change th...
Hi Manannalage, thank you for your reply i thought Cisco doesnt reply to my request i have attached you the output of the device, i don't have much knowledge can you check it and reply to me i am really devastated. regards
