Cisco Aironet 1310 flash memory test

[c.gebreselassie]

Dear Cisco Support Community 

i have a problem on one of my 1310 wireless bridge it is stucked on flash memory test and after resetting the baudrate to 115200

all i see on the bridge is status and Ethernet Leds are blinking green. 

Can you please help me?

[Abhishek Abhishek]

LED Indications

During access point operation the LEDs provide status information as shown in Table 5-1.

Table 5-1 LED Signals 

Message type	Ethernet LED	Status LED	Radio LED	Meaning
Boot loader status	Green	-	Green	DRAM memory test.
	-	Amber	Red	Board initialization test
	-	Blinking green	Blinking green	Flash memory test.
	Amber	Green	-	Ethernet initialization test.
	Green	Green	Green	Starting Cisco IOS.
Association status	-	Green	-	At least one wireless client device is associated with the unit.
	-	Blinking green	-	No client devices are associated; check the unit's SSID and WEP settings.
Operating status	-	Green	Blinking green	Transmitting/receiving radio packets.
	Green	-	-	Ethernet link is operational.
	Blinking green	-	-	Transmitting/receiving Ethernet packets.
Boot loader errors	Red	-	Red	DRAM memory test failure.
	-	Red	Red	File system failure.
	Red	Red	-	Ethernet failure during image recovery.
	Amber	Green	Amber	Boot environment error.
	Red	Green	Red	No Cisco IOS image file.
	Amber	Amber	Amber	Boot failure.
Operation errors	-	Green	Blinking amber	Maximum retries or buffer full occurred on the radio.
	Blinking amber	-	-	Transmit/receive Ethernet errors.
	-	Blinking amber	-	General warning.
Configuration reset	-	Amber	-	Resetting the configuration options to factory defaults.
Failure	Red	Red	Red	Firmware failure; try disconnecting and reconnecting unit power.
Firmware upgrade	-	Red	-	Loading new firmware image.
Controller status	Alternating green, red, and amber1			Connecting to the controller. Note If the access point remains in this mode for more than five minutes, the access point is unable to find the controller. Ensure a DHCP server is available or that controller information is configured on the access point.
Message type	Ethernet LED	Status LED	Radio LED	Meaning

¹ This status indication has the highest priority and overrides other status indications.

[c.gebreselassie]

and for this reason i am stucked. On the CLI there is Unknown character i cant login to the bridge any help on how i can login to the CLI will be appreciated