Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to get a Site to Site VPN tunnel with a Checkpoint Firewall. I have configured the vpn and it was established the first time. After some time of no use the tunnel was dropped but it didn't start again with interesting traffic. I reloade...
We have recently upgraded our switches to 3560x and I have updated the IOS to 15.0.2-SE7. The question I have is regarding the bootldr on the switch still showing C3560E ver 12.2(58)SE1. I'm assuming this is not going to be a problem in the future...
I'm new to cisco and currently building a midsize environment and wanted to know what is the best practices for administration management of cisco equipment? Thanks!
I'm new to cisco ASA's and I'm trying to create a Site-to-Site VPN tunnel to anothe asa but I'm unable to create an ikev1 policy, it doesn't even give me the option to in the asa running version 8.2(5)46, I have newer firewalls that are using this po...
I'm just starting as a Network Admin and I have been tasked to load 15 new switches WS-C3560X-48T-E V06, and 5 asa's ASA5525 V03. I want to get the lastest stable IOS levels to avoid having to make changes when they are put in production. Any Sugge...
Thanks Jon, If I have the below config'd now:crypto ipsec transform-set my_set esp-aes esp-md5-hmac crypto map RS_VPN 136 match address vpn_my_vpnACLcrypto map RS_VPN 136 set pfs crypto map RS_VPN 136 set peer 170.150.3.14crypto map RS_VPN 136 set t...
What would be the command? I have looked at the configuration in the 8.4 asa's and this is what I have. This doesn't work with 8.2:crypto ipsec ikev1 transform-set ESP-AES-128-SHA esp-aes esp-sha-hmac crypto ipsec ? no option for ikev1 Thanks,Mike
