Hi Friends,
I wanted to upgrade the ASA 5520 firewall version 8.2 to 8.4 ?
is there any risk to upgrade ?
does automatically old configuration is changed to newer configuration or shall i configure manually all the configuration after 8.4 upgradat...
I want to understand what is the use of NAT-T ?
i have gone through many documents but still confusing me.
we have a site to site vpns between two ASA firewalls , so i have disabled NAT-T on asa firewall but still both sites are communication each ...
Hi folks,
we have recently configured 3925 ISR router with T1 circuits. Everything is working normally
but when i give a command show ip interface brief
i could found my serials interfaces are showing unset even after reboot the router
Interfac...
Hi friends,
We have purchased Cisco VWIC3-2MFT-T1/E1 module for T1 circuits ( serial links)
what are the steps to installs this module on router ?
any commands are required to install this module ?
Thanks,
Shiva
Hi friends,
We have purchased Cisco VWIC3-2MFT-T1/E1 module for T1 circuits ( serial links)
what are the steps to installs this module on router ?
any commands are required to install this module ?
Thanks,
Shiva
Thank you so much marvin but my manager wanted me to upgrade to 8.4 version , i do not see any issues with current version on firewall though i have to do it
Thanks,
Shiva
Thanks masoud , you made me happy with your post and answer
but after disabling the NAT-T on ASA firewall still able to ping Destination IPs ?
tunnel is there between ASA to ASA firewall and disabled NAT-T on one firewall though able to ping both ...
Hi gpauwen,
below results are from other router but we havent configured any ip addrress on serial interface but still it is showing method is NVRAM
what could the issue.
Interface IP-Address OK? ...
Hi Peter,
Thanks for your reply .
we are able to ping both sides but we we are accessing using port (192.168.200.233:7777)
we are facing issue , not able to connect.