Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,Using the CLI on an ASA 5510 with ver8.3 (old style NAT) how can I tell what public IP Address is presented to an internet web server when my internal natted clients visit a website?If I do a:sh run | i natI get:nat-controlnat (inside) 0 a...
Hello all,I have a switch on a remote site that I need to act as a router. The switch is a cisco WS-C2960S-24TS-S I understand that in order to do this, the switch needs to have the LANbase SDM. This is my current setup:SW01#sh sdm prefer The current...
Hello All, So, I'm not normally a network engineer But have found myself in this most gracious position! I have this environment that I need to route IP across the switches. Basically, I have VM host server that has three network connections.NIC0 =...
Hi Karsten,Many thanks for this. Sorry for late reply... traveling back from the SYD office!Well spotted on ver! I have these things all over the world and they're all on different versions. As an ASA noob it took me a while to figure out there was ...
Mr DohertyThank you ever so much for your bad news Exactly the information I'm after. Even if I do have to buy a new switch Thanks all for any input.T
Agreed. That is the docs I've been looking at. It certainly says that I can do routing. Static routing is fine with me. My problem is that I don't know where to start!As a non Cisco head, I need to know my options. Clearly I could just buy a piece of...
