Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Router A is connected to Router B through a Point-to-Point connection. Router A, does not have a connection to the Internet. Router B has a Point-to-Point connection to Router, and a connection to the Internet. I created a tunnel between the route...
I have 3 ASR-1001-X routers. One router has two tunnels to each one of the other 2 routers. The other 2 routers only have one tunnel to the central router. Central router is on network 172.16, the other two routers are on networks 172.17, and 172.19....
Hi,I am trying to create a ICL to allow only Incoming traffic to IP XX.XX.XX.XX port 80But it does not work. Extended IP access list Outside-Traffic40 permit tcp any host XX.XX.XX.XX eq www900 deny ip any anyClass Map type inspect match-any Incoming...
Thank you, could you please let me know how that static route will look like. Tunnel between 16 and 19 has: Interface on router 172.16 has Ip 172.21.11.1, interface on router 172.19 has ip 172.21.10.1. Network behind 172.19 is 172.19.0.0 255.255.0.0,...
Hi,First of all, thank you very much for the support. I was able to pin all the routers, but now I cannot route the internet traffic of router 172.19 through router 172.16. Router 172.16 has a connection to the internet, router 172.19 does not. 172.1...
Router - Central - 172.16 - Tunnel 4 to Router 172.17 - Tunnel 4Router - Central - 172.16 - Tunnel 6 to Router 172.19 - Tunnel 6Not sure what you meant by "can you run any routing protocol this make one Spoke know about other Spoke LAN subnet " Sorry...
