Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Not sure if I am missing something, but when I use Cisco network assistant to have a look at port settings for one of my switches (Trying to set ESXi port speed to auto which is failing, so investigating negotiation settings on the switch), i...
Hi,I am trying to create a new etherchannel on one of our Catalyst 4506 switches, but when attempting to create this, I get an error that states:"Static mac entries are associated with <Interface>" It seems this is the case for any member ports I sel...
Hello, I am fairly new to Cisco, and am after a bit of help. My scenario:We have a new domain setup on a new VLAN (3), seperate from our current infrastructure VLAN (2).The new domain controllers provide DHCP for our new servers, and I would also lik...
Well it's a bit late, but the issue here seems to lie with vmware.
When I tried to change to auto negotiate for one NIC on one host via vcenter, it would fail. If I then did the same directly via the management interface for the host, it would comp...
Hi,The other end is an esxi host that is currently to 1000Mb, and is what I am trying to switch to auto.This times out though, which I suspect is because the port isn’t set to auto.I might try a physical disconnect tomorrow, but still seems a little ...
Odd, it must be a GUI thing, as I was able to add the ports to the channel-group using the CLI without any errors what so ever. Strange. Cheers for your input.James
Thanks for all the help everyone!I decided in the end to create a new VLAN, with a range of 10.100.0.0. 255.255.0.0 (a lot of 10.X between 0 and 100 are in use, so making it this high ensures I am not overlapping).I then set the IP helper address for...
Ok here goes.On my domain controller/DHCP server, I have a scope setup of 10.0.0.0 255.255.0.0, and is set with an IP range of 10.0.0.1 - 10.0.6.253I have various reservations in place, and a working policy to assign thin clients an IP of 10.0.2.X ba...
