Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
You might be right, but I also get the errormessage when I try to see the logs of the router specifically. Did you see any explicitreference on Cisco.com that PIX is NOTsupported? Note that in RME there arefilters which refer to PIX-* syslog mesage...
I have exactly the same problem.In my setup, the only syslog sources are an IOSrouter and a PIX, plus the CiscoWorks serveritself. I'm sure that the syslog messages ofthe router and the PIX are correct.Does anybody have an idea about the natureof th...
Concerning (1) : queueing takes place after ipsecThis means that congestion management QoStechnologies like CBWFQ and LLQ also takeplace after ipsec. If you want to do QoSbased on classification of the original(non encrypted) IP packets, then you ne...
I also experienced problems with WinXP/L2TP/IPsec<-> PIX 501.The problems seem to be related to the presenceof NAT. Using identical PIX and WinXPset ups, the IPsec debugging shows a differentbehavior when NAT is present between the WinXPand the PIX,...
