Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Yes, you are right that the setup is really easy and takes only a few minutes to setup. It is same as connecting the two switches togather with a crossover cable, but there are some differences.1. There is a Cisco proprietory cable that needs to b...
Hi Nunos,The only way that the config files are renamed is if the user presses the mode button for more than 10 seconds. The LEDs will start blinking after 3 seconds, and after 10 seconds the config files will be renamed and the switch will reboot. ...
Hi Nunos,The issue is that the configuration files are renamed to a new filename that is not known to the switch in its NVRAM. You need not reconfigure the switch.Please copy the following commands and paste it to get the configurations back.--------...
Hi Arturo,Generally these issues seem to more spcific to the NIC's that you use on the workstations/servers. Here is a link that will help you understand the issues and a NIC wise resolution for such issues.http://www.cisco.com/en/US/partner/products...
Hi,The 2980G switch are pure L2 switches and have a Cat4000 Sup2 architecture hence they only support CatOS and cannot support IOS.But in case of 2980G-L3, you have ONLY IOS running on them as they are L3 switches and can support L3 routing as well. ...
