Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure http probes on my Local director 430 running 4.2.3I am using http redirect mode so the Virtual is bound to URLs not REALs with are linked to DIPs which are bound to REALs. So far the probes seem to not actually do anything. ...
Sorry I see that rsh is supported here is the document. I think PERL would still be a good option but rsh seems to be more standard then I thought.http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800...
I would check the arp table on each host and the switch when this occurs next time and see if the correct mac address is there for Host A and B. Seems like it could be an arp problem related to the spanning, but that is just a guess. You also might...
IPX is supposed to be supported in High-Availability mode however DecNet is not. See the below section I copied from http://www.cisco.com/en/US/products/hw/switches/ps708/products_white_paper09186a0080088874.shtml------------------------------------...
I seem to remember a discussion with TAC about this. And I think it was that if you use the default group and dont specify then you can have 256 but if you use non-default group numbers then you can only have 16 per device. This was a while ago and...
