Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After quite some time my PI 2.2 server has finally been upgraded to PI 3.0.So the first thing , is to check out all the new features such as the PSIRT and EOL Report. The documentation all refers to the "Choose Reports > PSIRT and EoX." I simply cann...
Good day Is there any support for the Nexus C9372PX switch ? In PI 2.2 it is discovered as "unsupported Cisco device".According to Device Pack 4 , there are only 5 Nexus 9000 series switches support, yet the Datasheet states " The full line of Cisco...
Good day what are the Auto-Install options available for the Cisco Small Business 300 Series Managed Switch ?It would appear there are none, the operating system is not the standard IOS I'm used to.Would like to use it with Cisco Prime Infrastructure...
Good day.We're trying to run the DBSpaceReclaimer procdure, but is failing. LMS is 3.2 running on Solaris 10. Herewith the command we're using and its output:$ pwd/opt/CSCOpx/lib/jre/bin$ java -cp /Temp;/opt/CSCOpx/lib/classpath;/opt/CSCOpx/www/class...
We have LMS 3.2 for Solaris, with the latest CV device packages installed. For CAT65000IOS the version is 30.1. Looks like only the ACE10-* is supported for CiscoView. Looks like ver 30.1 has been released last year Dec, - anyone know when it will b...
As per marce1000 , perform a Backup, copy the backup file to the newly installed server and perform the Restore procedure.Your licenses will carry over within the backup.Cheers,PJ
Hi Brett
this is a R&D project on the cards for me too. Once I have this going I will share my results - I suspect careful consideration are to be applied in terms of polling cycles as well as the amount of devices.
cheers
Pierre
Hi Waldemar, I must admit, I didn't think your reply held much validity. But then I discovered the fine print in the "QuickStart Guide". On Page 6, below Table 3, displayed as a small footnote: "Compliance is supported on the Professional virtual a...
Hi, yes, I also found out the existing user gets overwritten. I do know however, the default FTP username is "ftp-user" . And it is not very well documented.Cheers
Hi a.gooding Have you had look at this document, It explains it quite well: http://www.cisco.com/c/dam/en/us/td/docs/net_mgmt/prime/infrastructure/2-0/user/guide/Cisco_Plug-n-Play-Solution-Guide.pdf.Cheers
