Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3524 that is stuck and am wondering if it is fixable. The error I see isInitializing Flash...flashfs[0]: sector 99, block 1 checksum (0xfb42 != 0xe2f0)flashfs[0]: writing to flash handle 0x75d588, device 0, offset 0x20000, length 0x208: Ille...
Am I off base thinking that I should be able to configure a ppp connection on the Serial interface of the WIC-1DSU-T1? I used to use it for a frame relay connection just fine and am trying to move to a standard T1 with ppp encapsulation and no authen...
Hey I just got a new AP1230b and when I try to get into it (through CLI enable or throguh website) it asks for a password and there is zero documentation as to what that password is (I believe they ship these with IOS now). Any ideas?
We want to connect our new 2600XM to our ISP through a full T1 (encapsulation frame-relay) and want to make sure what module we need for that. I think we can use a WIC-1DSU-T1 module but am not positive. Also, the wall jack from the ISP is labeled RJ...
thanks for the replies. the flash_init, load_helper and boot commands didn't help too much since it would say flash already initialized and then refuse too boot anyway. After trying a bunch of different things I finally try to method of resetting a f...
Thanks Tim, that link helped much. It pointed me in the right direction. The ISP we use only gives 23 channels since they have to run one voice by law so looking at the config example you sent made me remember that channel number. I appreciate the he...
