Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having trouble setting up RDP access to a LAN host from the WAN. I have used a few cisco guides to create the ACL/NAT rules to try to make this work, but I have been unsuccessful.
When I use the "packet trace" function it shows the packets ar...
I have run into a brick wall with a setup that should be straight forward. I am a novice VLAN troubleshooter, which doesn't help. First, the physical topology:Both SG300's are in L2 mode. The firewall (cyberoam) is setup with sub-intefaces & DHCP r...
I have been handed a fun job at work of breaking up a flat network into 4 vlans. This is my first "beginning to end" network project and I have a pretty good idea of what needs to happen, but its been my experience that what I have learned from book...
I am stumped on this one. I have a PoE 2960 that connects a few phone/workstation pairs to the network. All of them work correctly except for one...For example, the good / working configs look like this on the interfaces:interface GigabitEthernet1/...
I am trying to understand what I am seeing in this output. This is from a 3560 w/PoE._____________________TSG_SW1#show int trunkPort Mode Encapsulation Status Native vlanGi0/4 on 802.1q trunking...
Results of trace:
http://imgbox.com/pf4SNrcw
Am I using that utility correctly? The IP address field on the left is the public IP/WAN interface address. The field on the right is the host machines IP address.
Thanks MS, I have applied this change however this has not established RDP access. I am hoping to learn from this and I have spent a substantial amount of time trying to figure this out.
: Saved:ASA Version 8.2(5) !hostname enable password passw...
Using your suggested DHCP test pool on the switch I determined the VLANs did indeed work (at least on that switch). I was able to put ports into vlan 12, connect devices then communicate with those devices. I was still unable to communicate with dev...
Back with an update:I attempted to run the debug dhcp command, but I was unable. It appears as though the only debug command that can be run is debug and that's it (I get a <CR> if i put a "?" after debug). For this reason I was unable to troubles...
