Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,does anybody know where I could find an 7" MMCX to RP-TNC Pigtail for the AIR-PCI352 nic card ?The one ref AIR-420-1625-0500 is too short (5") for adding a secondary antenna to the PCI card...
Hello,I need to repeat a signal between a big wall.AP1-< ~ >-AP2-< ~ >-WGB1AP1 is rootAP2 is repeaterI know that using a splitter is not recommended in AP2. So on AP2 can I use an directionnal antenna directly attached to Right connector and a second...
I opened a tac case to cisco, I had the same problem than Daniel with EAP-TLS under Win2000 SP4 and 802.11b cisco cards.I tested the ACU on 9 Win2000 platforms, and always the same problem: nothing worked.The answer from cisco TAC was: "In regarding ...
Hello,I've the same problem with win2k sp4. No communication between the AP and the pcm350 client, so no debug possible.It seem like the driver stop working as it try to access the MS 802.1x layer.Does your problem was solved ?
I think you are wrong:The two directionnal antennas cover two different zone, the diversity feature must be set for the two connectors, what happen to one side when the over is communicating ?ref. "Multipath Distortion" chapter in http://www.cisco.co...
We install an AP with a splitter. Two directionnal antennas are connected to the splitter and directed in two different direction.No radio problems appear at all. Of course, the throughput is divided by 2, but it's normal.Cisco recommend to use a "go...
