Hi Kevin,
No need to add any static routes. The config posted above looks fine.
Please remember to select a correct answer and rate helpful posts.
Please open a new thread for any new query.
regards,
Bratin Saha
Cisco TAC
The link to refer here is as below:
http://www.cisco.com/c/en/us/td/docs/interfaces_modules/transceiver_modules/compatibility/matrix/40GE_Tx_Matrix.html
Don't see ASA listed here.
Please remember to select a correct answer and rate helpful posts.
...
Hi,
Is there a specific section where you are stuck or you have completed the configuration and don't see the tunnel coming up ?
With regards to the configuration document, please refer link below (see section "Configuring Basic VPN Settings (Site-to...
VLAN pair mode or VLAN group mode is mainly how the sensor interfaces are configured.
You can find more information on the same in the link below where they discuss the understanding and deployment of both modes.
http://www.cisco.com/c/en/us/td/docs/...
Answering both queries.
Yes the configuration posted by you looks fine and you need to have a similar configuration on the peer device (router or asa) with a mirror image ACL. Meaning that on the peer unit the ACL format would look like "SITE-B to SI...
