Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have got Cisco SG500-52 switch. There is 4 GBIC ports (it looks the same). I need to connect 3 other switches via optical fibre . If i put 3 GBIC inside, it is working only two. (there is no lights on third port ) It is possible to change ports m...
HelloI have fully working one wlan network - Office_wifi. I like to setup other one for Guest. I set two interfaces - first for office, second for guest. I created two wlans with SSID Office_wifi and Guest_wifi. I have got two routers, one for Offic...
Hello TomI have tried change mode to standalone (you can see it in screenshot). But my switch was not reacheble anymore via browser. So i had to do a reset switch to factory default. Do you have any ideas what was happen ?
I have exactly the same set up what you recommended. Problem was in "Fast SSID change"But, If i defined Vlans, it is stoped works. I can see other network if i dont have Vlans. Do you have any idea what is wrong ?thanks
Yes , there is WLC 7.4I have tried setup vlan ID, but i lost connection to the network - ok i will try it againI see two SSID from laptop, if i connect to for example to Office_wifi - its works well. But other network Guest doesnt (from different dev...
