Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, customer need is to have wireless LAN extension between two buildings at 500ft distance.My suggestion is to use 2x MR86 + 4x ANT-MA-27Will this be sufficient, or should we start looking at other vendors?Maybe someone has already this setup and ca...
Hi everyone,after solving issue with wrong VLAN configuration I have another one which I need help.This is my topology for the bridge connection:Issue:1. Trying to ping Interface VLAN 840 from Core to 3560, no response.....2. Then trying to ping DG 8...
Hi, we are trying to do bridge between two location(L2 LAN extension via WAPs), where we use these devices:2x MR86 - version MR 26.71x Cisco C9200L1x WS-C3560CX-12PC-SI have used this documentation:Extending the LAN with a Wireless Mesh Link - Cisco ...
Hello,Lets say I have two APs in mesh one as RootAP and one as MeshAP. Backhaul interface is 802.11a. The question is, is it mandatory to have 802.11a network enabled on WLC as well for APs to see each other?Thanks.
Gateway MR86:to Core to 3560 - no connectivityRepeater MR86:to Coreto 3560 - no connectivityBoth WAPs can reach core but none can reach 3560, after 3560 ping Gateway AP can ping but repeater no.
Hi, If there would be such ACL it would block the ICMP all the time right? And ICMP works in specific situation. From 3560 all the time. And no I am not aware of such ACL.
