About goodbyeblueskygoodbye

goodbyeblueskygoodbye · 05-18-2014

Good day all,I'm labbing some switching configurations as I work on CCENT/CCNA stuff and need some help. I have 2 switches connected on a trunk. SW1 is using port FA0/2 and SW2 is using port FA0/1. I wanted to disable autonegotiation on SW1 to observ...

goodbyeblueskygoodbye · 06-22-2013

Good day,I am using a SPA8800 as an analog gateway for a Business Edition 3000 deployment. I am now going to be going on my fourth replacement unit of the SPA8800 and am hoping someone at Cisco sees this post and can provide some insight.All of my fa...

goodbyeblueskygoodbye · 05-20-2014

Thank you all for your replies. Yes, it appears the straight through cable was the issue. When disabling autoneg on the 2960, that stopped auto MDIX. So, I turned it back on on the 2960 and disabled it on the 3550 by setting speed 100 and duplex full...

goodbyeblueskygoodbye · 05-19-2014

Hi, yes, I am using a straight thru cable. So disabling autoneg disables auto mdix as well? I did not know that! I will test turning off autoneg on the 3550 instead and leave autoneg on the 2960 and see if I get the expected results. As mentioned, th...

Member Since	‎06-22-2013 05:19 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	4

User Statistics

User Activity

Disable autonegotiation on switch ports results in interface going down?

SPA8800s keep dying (on my 4th replacement) - IS THIS A KNOWN ISSUE?

Thank you all for your

Hi, yes, I am using a