Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have Cisco 5505 on version 9.1 and Customer got Draytek Vigor 3200.We are trying to establish IPsec VPN but tunnels are not comming up and getting this logs on running command debug crypto ikev1 5.Sep 25 10:12:54 [IKEv1]Group = x.x.x.x, IP = x....
Hi ,Network structureSwitch A --- Customer firewall 1 | Switch B --- Customer firewall2May be some one can help me.There was a nagious alert yesterday and on investigation I found the 'Duplicate address x.x.x.x(VIP) on Vlanxxx, sour...
Hi,We have a cisco ASA 5510 running on Software Version 8.0(4)28.Recently we are seeing high cpu usage as below ABC-ASA# show cpu usage CPU utilization for 5 seconds = 53%; 1 minute: 43%; 5 minutes: 45%ABC-ASA# and I have notice its becuase of dispat...
Hi,I am implementing internet bandwidth HA provision to a customer.I am planing to assign 2 public ranges, /26 Public range for theirrouted network.I also want to assign /29 Handoff Network which will be configurebetween ASA outside interface and our...
Hi,I am preparing to replace the primary ASA in an HA pair and We want Failed Primary unit come as Secondary Standy.We are not replacing the hardware, was a PSU issue which is resolved now, so config is already there on Primary Failed ASA.My question...
Hi Luis, Appreciate your response.My customer has re-insert the pre-shared key its working at the moment.Thanks for your help.I will get back to you if I face any more issues.Thanks,Fahad
07-10-2014
Hi Sachin,
Can you confirm , is this still valid ?
IPS sensors do not support syslog forwarding
Thanks Julio,We are running DPI default and basic inspection setting as below.I will keep monitor the CPU usgae and traffic on ASA to see if got any sudden change. =========dynamic-access-policy-record DfltAccessPolicyclass-map inspection_default mat...
