Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Hesham,The way I provided to you is using Syslog messages rather than SNMP traps. Most of NMS has built in syslog server. Configuration sample below:logging enablelogging buffered informational ! in fact this one was only used to what exactly ...
Hi Bart,I would suggest to build full mesh of VTIs between the routers. Two VTIs from each router connecting to both routers on the other side. Inside VTIs and local networks you run dynamic protocol e.g. EIGRP - you will be able to control tunnels p...
Hi Hesham,It depends what kind of information level you want to get. - If you only want know that configuration was changed, but without details about what exact change was done, you can easily use logging to syslog server.http://www.cisco.com/en/US/...
Hi Ty,Assuming you run pre 8.3 OS version, then NAT configuration you showed is bidirectional as per http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/nat_static.html#wp1080960According to what taffic brings the tunnel up depends...
