Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a GRE tunnel connection setup between to clients. I am tring to to call the remote office over a Comcast Cable connection. The other party hear a a ringtone but when he answers the phone we get dead air, this is for calling both ways. But when...
Do we need to have voice capable switches with switchport voice command below. Is the parameter actually required? Switch# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Switch(config)# interface gigabitethernet0/1 Sw...
Do we need to have voice capable switches with switchport voice command below. Is the parameter actually required?Switch# configure terminalEnter configuration commands, one per line. End with CNTL/Z.Switch(config)# interface gigabitethernet0/1Switch...
Yes, we can reach both subnet across the tunnel using eigrp. Routing is good. Another addition is that we are not using our edge routers connecting that's connecting the tunnel as our voice routers. The voice routers on both sides are behind the edge...
We are connected via a GRE tunnel, while we have phones on each end registering on it own side, we can dial each other but no voice. Analog to digital work fine in both directions for voice. Do we have to be on the same subnet over the tunnel? Can yo...
We are connected via a GRE tunnel, while we have phones on each end registering on it own side, we can dial each other but no voice. Analog to digital work fine in both directions for voice. Do we have to be on the same subnet over the tunnel? Can yo...
