Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to limit traffic bound to specific subnets to 10Mbps. Scenarios as belowSource networks are 10.1.1.0/24, 10.1.2.0/24 and 10.1.3.0/24. Where as destination networks are 192.168.1.0/24 and 192.168.2.0/24What I want is, limit the traffic rate for...
Hello,The below is from Cisco Documentation. Can somebody explain this in easy way?"Note that the difference between using nat 0 with specifying network/mask as opposed to using an ACL that uses a network/mask that permits initiation of connections f...
Hello all,I am new to PIX and I would like to take the advantage of FO bundle (I learned it is the cheapest among all bundles). I am aware that I cant use Fo bundle as a standalone system (I read that it reboots once every 24 hours if I use it as a s...
Hi,I want to make DLSw as unintersting traffic to trigger the ISDN dial.IS below alone is enough or any additions requiredaccess-list 101 deny tcp any eq 2065 anyaccess-list 101 deny tcp any eq any 2065access-list 101 permit any anyThanks,Martin
I am facing a problem while redistributing between IS-IS and OSPF. I try to explain you belowA--------B-----------CA and C has 3 Physical (2Serial and 1Fastethernet) and a loopback interface. B has only 3 Physical interfaces and no loopback interface...
Maximum Mac addresses which 2950G/2950 can suport in CAM is 8000 as per CCO. Do you think u reach those many MACs?If your LAN is completely switched network then I dont think you exceed this limit.Hope above helps.
