Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is on UCCX 8.5I have a issue where the Cisco UXL Web service is in a STOPPED state!!Running this command:admin:utils service listI see the following:Cisco UXL Web Service[STOPPED] Component is not runningI then am trying to run this command:adm...
Scenario:The 7940 (SCCP) sets on the CME site can make and recieve calls to / from the CM site.The 9951 (SIP) set on the CME site can only make calls when the video is turned "OFF" on the set. When the video is turned "ON", the call does not establis...
Hi Aaron,docVar = Create File Document ("test.txt")docVar = docVar + '\r' + '\n' + "new line of text"write document (docVar to "test.txt") I can program the 1st and 3rd lines, how do I write the 2nd line?? Keeping getting an error whent using "SET" T...
Hi Suchitra,I am facing a similar issue between a CME and CUCM using a H323 link. - If the issue is resolved can you pls share the solution.Scenario:The 7940 SCCP sets on the CME can make and recieve calls to / from CUCM.The 9951 (SIP) set on the CM...
Hi Siva,SCCP IP Phone>CME>WAN>CUCM>IP phone is OKSIP IP Phone>CME>WAN>CUCM>IP phone is OK - with "Video" disabled on the set.SIP IP Phone>CME>WAN>CUCM>IP phone - FAILS when "Video" is enabled on the set.I have configured Bandwidth and Location on CU...
