Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a situation where I have an L2L connection to a cloud provider, which has it's own Internet connection. I'll call that cloud 10.3.0.0/24. That L2L connection comes in through an ASA I will call B2B. I have another ASA for incoming customer con...
I had a port-channel from a 6509 VSS pair into a 4948 that was monitoring a remote vlan into a physical port. Due to a physical layout change, the connection is now from the 6509 VSS pair into a pair of Nexus 5010's - which each have a port-channel b...
It appears that we are hitting 100% CPU ~every 30 minutes. When it hits, the main difference in CPU is from a process called 'iprouting.iosproc', which I haven't been able to find any good info on. As far as I can tell, it is not causing any dropped ...
How can I figure out where all my CPU is going? I get that the sum of the processes are off from the total of 93%, but they are SO off that I don't know where to start. Are any of these individual uses unreasonably high? TIA, Russell sh proc cpu | ex...
Can you do URL redirection on an ASA 5505?Here is the scenario. In our home office we are implementing NAC using Aruba ClearPass. So when a laptop plugs in to a wired port it gets a dhcp address and it's gateway is the Aruba Controller, which then se...
Yeah, that didn't work either. It would appear that the issue is that O-XLATE-CLOUD is an object-group, rather than an object, and has several other object-groups in it. All but one of the sub-object-groups could be objects, and then I could probably...
Well, since the little window on the right show 0 views, I'm going to propose an answer to my own question. I believe what I am doing falls under the category of "Dynamic Policy PAT", but I am trying to assign a particular IP on the INSIDE interface ...
I bounced the egress port on the destination 4948, which didn't change anything. I cannot drop a port-channel to the Nexus, as this is all production. I did notice that the appliance did seem to capture SOME packets this morning when I added vlan 102...
I would also like to point out that packets are incrementing on the egress port on the destination 4948, but the appliance is not seeing the packets. Nexus 1interface port-channel1 description Core switchport mode trunk speed 10000interface Ethern...
