Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I posted this a year or two ago but got no hits. Hoping there's finally a solution.
Client logs in with Anyconnect, gets an ip address, successfully connects with no problem. Everything works...
...until the user clicks "Disconnect". If he immediatel...
Hi all, there are a lot of posts on how to create a vlan bridge, but none seem to fit exactly what we need.
We have a number of hosts in vlan 1, but for various reasons we need to change the vlan id from 1 to 2.
Vlan 1 spans multiple buildings and sw...
Hi,
I'm trying to configure an ASA running 9.5.2.2 to use SNI (server name indication), so that I can have multiple certs on it.
It works if I connect to the device in the browser, but I get a certificate mismatch error with the Cisco AnyConnect Se...
After upgrading from 7.2 code to 8.2(5)58, my ASA5510's no longer allow more than four dhcprelay servers. This used to work, and I found no mention of it in the release notes.
I have more than four on my ASA5505's running the same code version, and ...
Hello - wondering if someone can tell me if there's a bug in the 8.2(5) code (I'm running the latest build, #58) related to ssh'ing into the appliance from a NAT'ed ip address.
My setup is like this:
my workstation (192.168.1.1)
|
ASA 5585-X (na...
Hi Patrick,
I do have ssh 10.1.1.1 255.255.255.255 outside.
I think you're on to something with the management-access command -- I'll try that and see if it works.
Thanks for your input on this!
Mike
An update on this: I have several ASA5510's, and one of them allows me to add five dhcprelay servers to the same interface -- they're both on 8.2(5)58. The only difference I can see is that the one that allows five has 1024 MB of RAM, while the one t...
Hi Rishabh, thank you for the quick reply. I'm a little perplexed about this -- any idea why was this changed between the 7.2 code and the 8.2.5 code? And why does it work on a 5505 running 8.2.5 and *not* on a 5510 running the 8.2.5 code? And why wa...
