Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a site with three sets of Cisco 3850 Stacks running IOS-XE 16.12.05b. The switches are configured for INSTALL mode, and all three stacks are configured to boot to packages.conf. The switches are on battery backups, but the site has had about...
Hello, Can anyone point me in the right direction to determine the maximum number of STP active ports a WS-C3850-48P switch stack can handle. Please see the output below. The command is a little mess when pasted into this thread, but this switch ha...
I'm getting stumped by what I think should be a simple issue. First, here's a layout of my network as prior to any changes:
Cisco ASA running 9.23 Base License acting as the default gateway (10.1.10.1) for a flat network. Authentication for remote ...
Please see the attached file for a topology of the relevant portions of this network. All but three of the APs at Building B are plugged into Cisco 3650 switches that are also acting as the WLCs. This allows for local switching of WiFi client traffi...
I have an SRST environment at my remote sites. My ATA's do not register back with CM after network connectivity is restored. I have to advise my end users to power cycle the device. I have read this discussion on the issue, but I do not have entit...
I believe it was you who recommended 16.6.9. I have changed the boot variable in HS-IDF-B to packages.conf. What I'm concerned out now is what is going to happen to switches 3-5 the next time there is a power outage (and with this customer, it's a...
Thanks! I want to make sure that it's clear that Switches 1-2 have a packages.conf file, and Switches 3-5 have a running-packages.conf file listed in flash. So just to confirm, all I have to do is change the boot variable to packages.conf, and then...
