Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to connect to a PIX with a Cisco VPN Client with MS CA (CEP). Enrollment and MSCEP works fine. All certificates are granted. ATTS are acceptable in debug mode, but the VPN Client always logs then following lines.337 16:55:36.762 09/12/03 ...
Hi,try that link maybe that will help you:http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094a5a.shtml#maintask1Good luckMarco
Hi Martin,we got the same problem with a few Realtek Chipsets and then an updated driver solved the problem.With the following drivers everything worked fine:http://www.nus.edu.sg/vpn/download.html#RealtekBut you should uninstall Cisco VPN Client bef...
Here a few debugs while connecting to the PIX:debug crypto isakmpcrypto_isakmp_process_block:src:217.185.70.154, dest:212.20.129.38 spt:500 dpt:500OAK_MM exchangeISAKMP (0): processing SA payload. message ID = 0ISAKMP (0): Checking ISAKMP transform 1...
Thank you very much for your quick ansewer.Today I tested the two commands but with no success.That's why I will send you a detail config, maybe that will help you to find my mistake.The VPN Client - Config:My VPN Client has two Certificates installe...
